Recleaning water filter

Filter media cleaning andreplacement of water / water filter is essential to be done to maintain the quality of the products so the results are as expected.

Late / neglected in clean drinking water filter will result in decreased quality of filtration. Here's how to clean the water Filter for drinking water refill depot and household

1.      The tube-shaped (with a lot of construction faucet) How to Clean Drinking Water Filter tube: First of all it must be ensured that water supplies for cleaning is enough to drain / pump ON position, it means do not do the cleaning at the time of water in storage tanks / reservoirs / Toren low .

For households, do not do the cleaning at the time of  tank was a small discharge of water / low pressure. This will result in less than the maximum cleaning results. Perform cleaning by BACK WASH / FLOW BEHIND, meaning that if the flow of water to the filter entry and exit from the top down, then to the BACK WASH is the opposite, namely the flow of water entering from the bottom and out from above.

Problem faucet which should open the lid you please use your own logic, because to explain it here a bit tricky due to the construction of water taps in the filter tube is different from one another (Sell Air Filter). If in doubt, you should contact the seller TSB tube.

2.      Shaped Tubes (With Three Way Valve valve) How to clean tubes Fiber (Wave Cyber, Pentair, Stainless): Among the easiest types of cleaning tube is a tube with a three way valve faucet is. First of all, just as above, be sure to clean water in a state containing / pressurized and not empty.

Then close the tap out (if any) so that the dirty water when not wash back into the home / holding tank. Next follow the instructions written on the faucet body three way valve (Sell Air Filter).

·         For cleaning the place position on the paper back wash valve, it will come out of the dirty water drain pipe.

·         To place the flushing valve position in writing Rinse, then it will come out in the rinse water discharge pipe.

·         When finished, place the valve position on the writings of Drinking Water Filter.

Additional notes: usually to wash back up to finish the process took 15 s / d 30 minutes (depending on water turbidity). In the first 10 minutes of tap positions should be transferred to the pattern: Back wash ----> Rinse ----> Back wash ----> Rinse with breaks every 2 minutes until the water comes out really clean. If it is clean please move to filter position and finish.